Plus sometimes in order to keep casts the highest quality; we use some release agent, to get the miniatures out of their moulds more easily. The oil from the moulds or the release agent can repel paint and glue, so it is best that the surfaces are cleaned. Use an old toothbrush and some warm water with'washing up liquid' to gently brush the pieces clean (be extra careful of delicate pieces, so you that you don't snap them). Make sure you rinse the parts afterwards and allow them to thoroughly air-dry.Resin is very detailed, yet sometimes thin parts may be bent slightly during transport or storage. It is simple to fix as resin has a "thermal memory" like a thermoplastic. It remembers the shape it was cast in. So simply run the part under a hot tap or use boiled water to heat and soften it. Then you can bend it carefully back into shape. Let it cool by quenching in cool water, pretend you are a fantasy blacksmith and the resin will set like this in the shape you want. We try to produce minis without massive hideous mould lines, flash, vents, air bubbles or other things that cause you a headache. But, try as we might, we are not yet! Perfect and sometimes you will need to call upon your hobby skills to tidy up a part.
Just like you would with plastic minis - use some hobby clippers to snip off any casting gates (aka: those rods/ sprues /supports) mould lines may need to be scraped or lightly sanded away with a file or hobby knife and any flash can also be removed in this same way. To glue resin, you should use Super Glue Cyanoacrylate. If you rough up the surface of the bond with sandpaper or scratch it a bit first - you will get a stronger bond. Another good trick is to use water to make one part damp not wet! And apply the glue to the second part.The bond will be much quicker. You can also use superglue accelerator in the same way.
If you glue your fingers or something you want to remove the glue from, you can use pineapple juice (useful and delicious) or super glue remover. Some larger pieces may need to be pinned in place like how you do with metal models. In rare cases for huge joins where you want the ultimate bond - Two part epoxy glue can be used.
All done, you model is cleaned, prepped and assembled. Now you are ready to prime your model as per usual and start painting. We recommend a light dusting with an aerosol spray primer or good airbrush primer. Resin is great, but be careful not to breathe in too much of the dust when sanding or drilling it. So when making a lot of dust - either do this outside or use a face mask dust mask.
For this reason, we don't recommend resin miniatures to unsupervised persons under the age of 13. Resin miniatures are not a toy.
Small parts are a choking hazard to infants under the age of 3. We will respond to you within 3 hours and do our best to help you out!Please make sure your address is valid. All packages can be tracked until you receive them. Any product you return must be in the same condition you received it and in the original packaging. It will be a great thing for us. We will sort out the issue.
This item is in the category "Toys & Hobbies\Models & Kits\Figures". The seller is "dwstorelk" and is located in this country: CN. This item can be shipped worldwide.